Change a Propane Tank
Forklifts powered by propane are common in warehouse settings. These forklifts have a propane mount situated at the rear of the operator. These tanks have to be replaced from time to time because they have limited lifespans. Operators of forklifts should use care when handling propane tanks. Compressed gases are very dangerous, especially because the gas is flammable. Use caution when replacing and removing propane tank to avoid injury.
1 If there is a need to change the propane tank, the first step is to stop the lift truck, then turn the tank valve off. The forklift must be left on until the engine dies. This procedure burns the gas off in the transfer hose which connects the tank and the engine. Before taking the second steps, put on the proper safety equipment, such as insulated gloves made of either leather or neoprene. It is vital for you to protect your skin from contact with the compressed gas, that is very cold.
2 The hose of the tank needs to be disconnected, followed by removing the tank from its holding straps. When you put in a new tank, tighten the nut to reconnect the holding straps and to reattach the hose at the valve of the tank.
3 You could inspect for leaks by applying soapy water to the valve and slightly opening it. Leaking gas will cause bubbles to froth around the value. If this occurs, check the connection hose at the nut and the valve area. The connecting nut must be re-tightened if you detect any leaks around the area of the valve, and after that do the leak inspection procedure all over again. Persistent leaks mean that the connecting hose and nut should be replaced. However, if replacing the hose and nut still does not stop the leak, the tank will need to be replaced.
4 Lastly, open the valve all the way to enable the gas to fill the connecting hose. Then you can start the lift truck and continue working.